信息 联系我们
首页 首页 / 博客
热门标签
为什么夹紧吨位无法在注塑机上精确定塑化驱动器的尺寸
An OEM engineering review of what clamping force cannot tell you about the plasticizing gearbox, and which screw and drive data matter instead.
作者明夜
2026-10-22
齿轮箱安装在机床底座上，输出轴与驱动轴相连，并可见油镜
油泵运行并不能证明每个轴承都润滑了
A practical distinction between pump pressure and actual oil supply to gear meshes and bearings, with safe verification and startup evidence requirements.
作者明夜
2026-10-22
双辊开式混合轧机齿轮箱
Two-Roll Rubber Mill Friction Ratio: Check the Actual Drive Layout
Understand the difference between roll RPM and surface-speed ratio, then verify which parts of the actual two-roll mill drive establish that relationship.
作者明夜
2026-10-22
蜗轮螺丝减速器
旅行在表面上是完全正确的: 为什么螺旋千斤顶仍然会短暂停止
A practical review of screw-jack lead, 比率, travel limits and machine clearance, with a warning against assuming nominal stroke or self-locking.
作者明夜
2026-10-22
双螺杆挤出机高扭矩变速箱
双螺旋挤出机变速箱改装: 先检查轴心距离
A drawing-first review of twin-screw extruder gearbox replacement, where shaft geometry and rotation arrangements must match before torque approval.
作者明夜
2026-10-22
工业用旋形齿轮减速器
环形减速器输出密封泄漏: 更换前需要检查的事项
Evidence-led checks for cycloidal output seal leaks, without treating a new seal or a single gauge reading as conclusive diagnosis.
作者明夜
2026-10-22
用于校历机的重型齿轮箱
历书间隙变化: 驱动联结器必须容纳什么?
An OEM drawing review of roll positions, cardan shaft angles and coupling misalignment across the usable calender gap range.
作者明夜
2026-10-22
行星转向驱动
液压转向驱动无法旋转: 独立电机, 刹车和变速箱故障
液压转动驱动故障的症状指南, 分离制动释放, 液压供应和机械传动，避免不安全测试.
作者明夜
2026-10-22
一体化齿轮电机，旁边有独立电机, 联轴器和变速箱
冷校准后的热工业变速箱联轴器: 需要注意的事项
复查冷车和运行中的定位, 热运动和耦合导致的原因是不将2×振动信号视为唯一诊断.
作者明夜
2026-10-22
内部混合变速箱
橡胶内部混合变速箱: 读取批量加载配置文件, 不仅仅是电机千瓦
电机电流趋势差异的OEM指南, 实际功率, 橡胶内部混合器中的批量扭矩峰值与双转子负载分担.
作者明夜
2026-10-22